Formulas
| Case | Max deflection | Max moment |
|---|---|---|
| Simply supported, centre point load P | PL³ ÷ 48EI | PL ÷ 4 |
| Simply supported, uniform load W (total) | 5WL³ ÷ 384EI | WL ÷ 8 |
| Cantilever, end point load P | PL³ ÷ 3EI | PL |
| Cantilever, uniform load W (total) | WL³ ÷ 8EI | WL ÷ 2 |
E is about 200 GPa for steel, 69 GPa for aluminium and roughly 8–14 GPa for structural timber. I depends on the cross-section; for a rectangle it's width × depth³ ÷ 12.
Example
A 4 m simply supported steel beam (E = 200 GPa, I = 8,000 cm⁴) with a 10 kN load at mid-span deflects 10,000 × 4³ ÷ (48 × 200×10⁹ × 8×10⁻⁵) = 0.83 mm, with a maximum moment of 10 kN·m.
Tips
- This ignores the beam's own weight unless you add it to the load, and doesn't check strength or buckling.
- Structural designs must be checked by a qualified engineer against local building codes.
- For loads and forces, see the force calculator.
Frequently asked questions
What is L/360?
A common limit: deflection shouldn't exceed the span divided by 360 for floors with plaster ceilings.
How do I find the moment of inertia?
From steel section tables, or width × depth³ ÷ 12 for a solid rectangle.
Does doubling the depth halve the deflection?
Better: it cuts deflection to one-eighth, because I grows with depth cubed.
Written and checked by Vijay. Last updated .